Is the theft light blinking real fast when you try to start it? if it is then it has to go to the stealership for repair. I just had the samething happen to mine. It cost $200 for a $15 part
Took it to Auto Zone & put it on their computer. It came back as lean 1&2 bank. He found my PCV hose had a big hole in it causing it to run lean. $18 later fixed & ready to roll. Not to mention the guy who works there found the leak took it off & put the new one on for me!!:D
It came on the other day. So i took it to the parts store & put it on the diagnostic machine. It came back as a lean condition. The guy said thats all it shows up as. I'm thinking possibly the ethanol gas 10% mixture is causing it. Any other ideas?
well the dealer just called me. he said it was a bad PCM relay or a ECM relay. it was one of the 2. Total cost was $185. Thats A LOT cheaper than what i was expecting
had any luck with getting it fixed? Im kinda in the same boat. sometimes the odo will work sometimes it wont. The other day i couldnt get it to start. the theft light was blinking fast waited 5-10 minutes with key out of the ignition & it started. its been sitting in the yard since then. going...
My 99 is starting to do this. I put the key in & turn it to the "on" position & the theft light is blinking real fast. Had a mechanic come look at & reset it. He said a gin module could be going bad. ive read about the PATS system, but havent seen anything about a gin module. I only have 1 key...
I used one tube of the limited slip additive. With the regular gear oil. I used 80w-140. Its a little bit heavier than what it called for in the synthetic. I found some syn. for $7. a bottle. So i guess I will drain it & fill it up again. Also the ABS light is on. I disconnected the plug blew it...
I have a 99 expy. It sat in water for about an hour one night waiting to get pulled out. I changed the fluid in the rearend (thiniking I had water in it. It didnt) when I start off & i'm turning it feels like the rearend is wanting to slip. Do I need to change the fluild again? Any suggestions?
Woooo Hoooooo!!!!! Its back running. I removed the fuel tank, charcoal canister & the fuel filter. I cleaned out the tank & canister, replaced the filter. For future reference it takes a 5/16's fuel removal tool. Thanks for all the help!!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.