Search results

  1. M

    07 expedition Electronic Stability Control light on

    never mind no one is going to answer this i figured it all out on my own
  2. M

    07 expedition with abs code c1288

    Bueller Bueller Bueller Anyone Anyone Anyone
  3. M

    07 expedition with abs code c1288

    abs code c1288 comes up on this 2007 expedition says brake pressure transducer fault this has the roll stability control and the sliding car icon is lit all the time as well any ideas ? where is this part located ? anyone know the ford Part number ? What vendors have this part?
  4. M

    07 expedition Electronic Stability Control light on

    From my research wheel Sensors dont look to have anything to do with it . they throw abs errors. it could be light coming in on top of the dash hitting a wheel and sensor on the steering column under the dash Block with some foam rubber or cardboard and check to see if light...
  5. M

    07 expedition Electronic Stability Control light on

    so replace L or R front sensors and that will for sure turn off the sliding car icon ?
  6. M

    07 expedition Electronic Stability Control light on

    Electronic Stability Control light sliding car icon is on all the time press button on dash it does nothing hold button down and it flashes and comes back on how do you clear it or turn it off ?
  7. M

    07 with cyl 6 misfire help

    IT IS NOW FIXED !!!!!! ONLY USE SP515 Motorcraft spark plugs in this vehicle I tested compression to 100 on cyl 6 - this one was the 1 with the issue tested compression to 102 on cyl 5 so i went to autozone and replaced the new autolite ht1 plug with the motorcraft sp515 plug and...
  8. M

    07 with cyl 6 misfire help

    so now all 4 o2 sensors installed and its running 90% better but ... still have cylinder 6 misfire come on at 65mph so i will await the compression hose to fit this vehicle for my tester
  9. M

    07 with cyl 6 misfire help

    ok changed the 2 upstream o2 sensors today i had to heat up the passenger side with a torch to get it out after installing i cleared codes and it ran really great i kept it under 45mph for 2 days no check engine code came on also the IM's came up ok really quick on the drive cycle...
  10. M

    07 with cyl 6 misfire help

    i have all 4 o2 sensors ordered from ebay along with a compression hose to fit this spark plug hole
  11. M

    07 with cyl 6 misfire help

    and took off maf sensor and cleaned with maf sensor spray used air to blow it dry no change
  12. M

    07 with cyl 6 misfire help

    changed out crankshaft and camshaft sensors today and a new fuel filter that took 5 minutes on the sensors and 30 on that big port of the fuel filter it was a hard one even with the disconnect wrench cleared codes drove it under 45 mph it was fine for 15 mintues i went up to...
  13. M

    07 with cyl 6 misfire help

    help .... cyl 6 misfire 07 expedition friend had a snap on scanner tool shows all plugs good shows all coil on plug good and within tolerances shows all fuel injectors good clear code and it comes back after 40 mph or so changed air filter changed fuel filter changed crank...
  14. M

    07 with cyl 6 misfire help

    Cleaned mass air flow and new air and fuel filters See above
  15. M

    07 with cyl 6 misfire help

    Latest Local ford dealer wanted 956.00 to change out fuel injector. I laffed Took to a real mechanic. Found all plugs good. They r all new Found all 8 coil on plug good. All new too Found all injectors good. 1 on 6 new Compression 90 on cyl 6 Should be 105-150 I bet head on cyl 6 side...
  16. M

    07 with cyl 6 misfire help

    yes i did change out the spark plug #6 with another new one from another store
  17. M

    07 with cyl 6 misfire help

    only code is cyl 6 misfire and it runs ok cold when it gets warm and we get to 45+ mph it comes on
  18. M

    07 with cyl 6 misfire help

    update for today moved the cyl 6 fuel injector to 3 got the same code after clearing it put in hi octane gas and also seafoam it works until you get on it like from 40-75 mph then it flashes check engine and goes out pending probably and after 2-3 times it stays orange i...
  19. M

    07 with cyl 6 misfire help

    doesnt any one have an answer on this ? 07 expedtion with cyl 6 misfire changed plugs changed out all coil on plugs took off fuel rails and cleaned all the fuel injectors cleared code and drove it now says cyl 6 misfire again checked compression on 6 and its the same as on 3...
  20. M

    07 with cyl 6 misfire help

    i took 5 and changed the coil on plug with 6 and 6 still throws code misfire. the plug is good and tight i checked it and there is 12 volt to it pulsing what else could it be >?
  21. M

    07 with cyl 6 misfire help

    2007 expedition - changed all the plugs with HT1 platinum and also changed the coil on cylinder 6 - i looked up that cyl 6 was the 2nd one from front of engine on driver side pass driver firewall 4 8 3 7 2 6 **** 1 5 grille of front took...

Latest posts

Members online

Total: 1,327 (members: 19, guests: 1,308)

Forum statistics

Threads
53,737
Posts
503,320
Members
47,401
Latest member
oldsparky33

Share this page

Top