SyndicateZ
Full Access Members
Would be cool if u could change the color too
Last edited:
increase drl brightness expedition platinum 2018
- Thread starter ahammed akkif
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
ahammed akkif
Member
When the vehicle is locked the drl light flashes.
ahammed akkif
Member
I think it can be adjusted like the F150. Is there any forscan expert on this
ahammed akkif
Member
Can you share a photo of your vehicle's DRL. during the day
SyndicateZ
Full Access Members
Ok I will a little later today when I go out. Ill post on here
SyndicateZ
Full Access Members
Its daylight but under tree cover
ahammed akkif
Member
My expedition drl is not that bright. Is there any forscan code for brightness
Left Coast Geek
Full Access Members
afaik, those LED DRL's are either on or off. would require a new custom built headlight bucket to change that.
HILLY
Well-Known Member
Reading through the F-150 14G Forum, this should be the same, or close to it.
1. Revert/restore your changes in FORScan that you did for the above change via backup that you made to restore back to factory as-built values for line - BCM: 726-42-01 -> x2x2 xxxx xx--. Make sure to write and cycle your truck on/off.
2. Go into BCM as-built once again and create a backup once more, to be safe.
3. Change the following as-built with the following values. The preferred value that has been tested as of May 2022, is 4B (75%). Change only the "**" area, and leave the rest of the values in the line the way they are as default.
726-38-01 xxxx **xx xx--
64 =100%
5A = 90%
4B =75%
32 = 50%
19 = 25%
0A =10%
3. Write to the truck and cycle the truck on/off, a few seconds apart. Enjoy!
1. Revert/restore your changes in FORScan that you did for the above change via backup that you made to restore back to factory as-built values for line - BCM: 726-42-01 -> x2x2 xxxx xx--. Make sure to write and cycle your truck on/off.
2. Go into BCM as-built once again and create a backup once more, to be safe.
3. Change the following as-built with the following values. The preferred value that has been tested as of May 2022, is 4B (75%). Change only the "**" area, and leave the rest of the values in the line the way they are as default.
726-38-01 xxxx **xx xx--
64 =100%
5A = 90%
4B =75%
32 = 50%
19 = 25%
0A =10%
3. Write to the truck and cycle the truck on/off, a few seconds apart. Enjoy!
You previously posted this via a link… the OP tried it, it didn’t work… reposting it won’t change anything…
F150 coding doesn’t always work for the expedition, also consider this code came from the 2021+ f150s which are a whole 2 generations newer than the platform the 2018-2021 expeditions are coded on. In reality the code for 2015-2018 f150s is the closest coding for the 2018-2021 expeditions.
Similar threads
