Search results
-
PATS system
if I get another gauge cluster and get the dealership to reflash that and the pats system would that work? I just had a new key made and programmed to the Pats on the steering column- Johnb1019
- Post #3
- Forum: 1st Gen - 1997 - 2002
-
PATS system
Ok this is the problem im having for no starting, got a new set of keys made, checked all the fuses, and the scan from the ford dealership is saying that the computer is not communicating with the rest of the system, It takes a few minutes for the gauges to move, Dealership saying possible bad...- Johnb1019
- Thread
- Replies: 3
- Forum: 1st Gen - 1997 - 2002
-
no start
yes the interior lights work and door ones, it was running but missing before i did the big tune up, now it turns over but not firing, i know the injectors are good and new coils, spark plugs, new fuel filter,- Johnb1019
- Post #3
- Forum: Engine & Performance
-
no start
I have a 99 ford expedition with the 5.4. i just did a tune up on it, spark plugs, new coils, and even a new cam sensor, the problem is that not running. It wil turn over but no fire, One indication is the guage cluster doesnt work, usually when u put the key in and turn to ON position, the...- Johnb1019
- Thread
- Replies: 3
- Forum: Engine & Performance
-
Reverse lights
hello I have a problem and have no clue where to look at, i have no reverse lights when i shift it into reverse, Ive check the bulb socket with my tester with the parking brake on and the ignition on but not running, is there a fuse or a relay that controls the signal? also I have been thru the...- Johnb1019
- Thread
- Replies: 3
- Forum: Electrical
-
Good headlight bulbs?
Yea I got HIDS in mine, I think theyre 8k or 10k, but yea I pulled them out of my 95 caprice and hooked them up to the expo, they look better in it then the caprice. Im ordering the crystals clear headlights with the LED strip under them and the corner lights are LED, I'll get a picture when...- Johnb1019
- Post #25
- Forum: 1st Gen - 1997 - 2002
-
Ok guys i have decided to redo exhaust
Yea im looking at this post too, I want somthing louder than stock but not like race car loud, i like a deeper tone and rumble,- Johnb1019
- Post #18
- Forum: 1st Gen - 1997 - 2002
-
no start
Hey i found the reason the starter wouldnt work, when the tranny went out it locked up the shaft inside of it and the starter couldnt turn it over, but thanks for your imputs!- Johnb1019
- Post #7
- Forum: Electrical
-
Rough Idle
It idles between 1 and less, somtimes going up then going down, if i dont hold the gas pedal it will stall in a couple mins, anyone had the same problem? thanks- Johnb1019
- Thread
- Replies: 0
- Forum: Electrical
-
slipping
Update on transmission, it was toasted, the foward clutches were burnt out, the shaft machined down the spines or threads on the bearings or somthing like that, I've seen the parts the shop pulled out and they put a brand new overhaul kit in it. It cost $1500 dollars cash i paid, and came with a...- Johnb1019
- Post #9
- Forum: Transmission & Drive train
-
no start
that sounds possible, cause i did notice the starter would act like a low battery, but the battery and alternater is new, ill check the starter, thanks- Johnb1019
- Post #4
- Forum: Electrical
-
-
Three rows of Roush Leather seats for Expedition
Do you have the tan ones and a good picture of them? -
no start
I have a 99 expo with the 5.4, and the problem is that when i put the key to turn over it doesent do anything, all the lights go dim and nothing else happens, but i can pop the hood and touch the coil with a wrench making a complete curcut and it would crank right up, with the key in the on...- Johnb1019
- Thread
- Replies: 6
- Forum: Electrical
-
slipping
Its 2wd, yes i put a new filter on it, im not sure about if i change out an O ring on it or if the new filter had a new one on it, I just know that when u install it that it clips in place. A friend of mine said that its possible that the friction bands are fried, but i changed the fluids in it...- Johnb1019
- Post #7
- Forum: Transmission & Drive train
-
slipping
Hi Im new to this forum but im clueless of what to do in my situation. I bought a 99 expo last year around tax time, and since then while shifting from park to reverse or drive, it would slip, then finally catch and go. Ive changed the fluids and changed the filter, and still had the same...- Johnb1019
- Thread
- Replies: 8
- Forum: Transmission & Drive train
